webcam/mic

classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

webcam/mic

Bryan Irvine
This might be dumb question, but I haven't found the answer anywhere
else yet.  I have a lemote 8089b and I'm trying to figure out what
software I'd use in order to use the webcam/microphone.  I'm not
trying to solve any particular problem other than my own curiosity of
how I'd record/ take pictures (video chat would be cool too but is
only a bonus).

Here's my dmesg:

OpenBSD 5.0 (GENERIC) #26: Wed Aug 17 10:41:08 MDT 2011
    [hidden email]:/usr/src/sys/arch/loongson/compile/GENERIC
real mem = 1073741824 (1024MB)
avail mem = 1059209216 (1010MB)
mainbus0 at root: Lemote Yeeloong
cpu0 at mainbus0: STC Loongson2F CPU 797 MHz, STC Loongson2F FPU
cpu0: cache L1-I 64KB D 64KB 4 way, L2 512KB 4 way
bonito0 at mainbus0: memory and PCI-X controller, rev 1
pci0 at bonito0 bus 0
rl0 at pci0 dev 7 function 0 Realtek 8139 rev 0x10: irq 5, address
xx:xx:xx:xx:xxxx
rlphy0 at rl0 phy 0: RTL internal PHY
smfb0 at pci0 dev 8 function 0 Silicon Motion LynxEM+ rev 0xb0
wsdisplay0 at smfb0 mux 1: console (std, vt100 emulation)
ohci0 at pci0 dev 9 function 0 NEC USB rev 0x44: irq 7, version 1.0
ehci0 at pci0 dev 9 function 1 NEC USB rev 0x05: irq 7
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 NEC EHCI root hub rev 2.00/1.00 addr 1
glxpcib0 at pci0 dev 14 function 0 AMD CS5536 ISA rev 0x03: rev 3,
32-bit 3579545Hz timer, watchdog, gpio
gpio1 at glxpcib0: 32 pins
pciide0 at pci0 dev 14 function 2 AMD CS5536 IDE rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <FUJITSU MHZ2160BH G2>
wd0: 16-sector PIO, LBA48, 152627MB, 312581808 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 ignored (disabled)
auglx0 at pci0 dev 14 function 3 AMD CS5536 Audio rev 0x01: isa irq 9,
CS5536 AC97
ac97: codec id 0x414c4760 (Avance Logic ALC655 rev 0)
audio0 at auglx0
ohci1 at pci0 dev 14 function 4 AMD CS5536 USB rev 0x02: isa irq 11,
version 1.0, legacy support
ehci1 at pci0 dev 14 function 5 AMD CS5536 USB rev 0x02: isa irq 11
usb1 at ehci1: USB revision 2.0
uhub1 at usb1 AMD EHCI root hub rev 2.00/1.00 addr 1
usb2 at ohci0: USB revision 1.0
uhub2 at usb2 NEC OHCI root hub rev 1.00/1.00 addr 1
isa0 at glxpcib0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
mcclock0 at isa0 port 0x70/2: mc146818 or compatible
ykbec0 at isa0 port 0x381/3
usb3 at ohci1: USB revision 1.0
uhub3 at usb3 AMD OHCI root hub rev 1.00/1.00 addr 1
clock0 at mainbus0: ticker on int5 using count register
apm0 at mainbus0
umass0 at uhub1 port 1 configuration 1 interface 0 Generic USB2.0-CRW
rev 2.00/58.87 addr 2
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <Generic-, Multi-Card, 1.00> SCSI0
0/direct removable serial.0bda0158114173400000
urtw0 at uhub1 port 4 Realtek RTL8187B rev 2.00/2.00 addr 3
urtw0: RTL8187B rev E, address xx:xx:xx:xx:xxxx
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
pmon bootpath: /dev/disk/wd0
boot device: wd0
root on wd0a swap on wd0b dump on wd0b
WARNING: / was not properly unmounted
ehci_idone: ex=0xc000000000088200 is done!
ehci_idone: ex=0xc000000000088200 is done!
apm0: battery high
urtw1 at uhub1 port 2 Realtek RTL8187 rev 2.00/1.00 addr 4
urtw1: RTL8187 rev 0x04, RFv2, address xx:xx:xx:xx:xxxx

Reply | Threaded
Open this post in threaded view
|

Re: webcam/mic

Miod Vallat
> This might be dumb question, but I haven't found the answer anywhere
> else yet.  I have a lemote 8089b and I'm trying to figure out what
> software I'd use in order to use the webcam/microphone.  I'm not
> trying to solve any particular problem other than my own curiosity of
> how I'd record/ take pictures (video chat would be cool too but is
> only a bonus).

The webcam doesn't show up in dmesg on the 8101 and the late 8089
models. I've been trying to fiddle with the registers that supposedly
enable it, with no reproduceable results, and eventually gave up.

If you're lucky, the webcam enable key combination (should be something
like Fn-F2) will make it appear and attach as an uvideo device. But I
wouldn't hold my breath on this.

Miod

Reply | Threaded
Open this post in threaded view
|

Re: webcam/mic

Bryan Irvine
On Wednesday, April 11, 2012, Miod Vallat wrote:

> > This might be dumb question, but I haven't found the answer anywhere
> > else yet.  I have a lemote 8089b and I'm trying to figure out what
> > software I'd use in order to use the webcam/microphone.  I'm not
> > trying to solve any particular problem other than my own curiosity of
> > how I'd record/ take pictures (video chat would be cool too but is
> > only a bonus).
>
> The webcam doesn't show up in dmesg on the 8101 and the late 8089
> models. I've been trying to fiddle with the registers that supposedly
> enable it, with no reproduceable results, and eventually gave up.
>
> If you're lucky, the webcam enable key combination (should be something
> like Fn-F2) will make it appear and attach as an uvideo device. But I
> wouldn't hold my breath on this.
>
> Miod
>

I tried both with and without holding my breath with no luck.